Skip to content
+1 734-761-8989

Same Robot, Same Program, Different Bead: How Cold Weather Affects Adhesive Dispensing

Temperature Changes Quality in Dispensing

When the season changes, so does your bead

Nothing in the cell has changed. The robot is the same, the program is the same, and the dispense settings haven’t been touched. Yet as temperatures drop in the fall, many plants start seeing adhesive beads that don’t match what they saw all summer.

The cause usually isn’t the equipment. It’s the material. Adhesives and sealants respond to temperature, and a cooler plant floor, colder incoming drums or longer cold-weather storage can quietly change how material flows through your dispensing system.

How temperature affects adhesive viscosity and bead volume

Viscosity is a material’s resistance to flow, and for most adhesives it rises as temperature falls. Thicker material moves through hoses, valves and nozzles more slowly.

If the dispense settings stay fixed while the material thickens, the system can deliver less adhesive per millimeter of bead. The robot path and speed are unchanged, so the result is a bead that is thinner or smaller in cross-section than the process was designed for. Because this happens gradually as conditions shift, it often goes unnoticed until it shows up as a quality issue downstream.

A good-looking bead isn’t always a good bead

A bead that is continuous, straight and in the right position can still pass a visual check. But joint strength depends on volume, not just appearance.

When less material is applied, there may not be enough adhesive to fully wet out both surfaces or fill the joint as designed. That can mean reduced bond strength, leak paths in sealing applications or weak spots that only show up in testing, field returns or warranty claims. Presence and position checks alone won’t catch a bead that is in the right place but short on material.

Why the usual fixes don’t last

Most plants handle seasonal material variation in one of three ways:

  • Manual parameter adjustments: Technicians raise pressure or flow settings when beads start to look light.
  • Extra inspections: More manual checks, cut-and-measure samples or added operators to watch the line.
  • Constant re-tuning: Revisiting dispense settings shift after shift, and again when the weather warms up.

These approaches work until conditions shift again. They depend on someone noticing the problem first, they add labor and they react after the bead has already drifted. Temperature doesn’t change just once a season, either. It moves between morning and afternoon, between day and night shifts and with every new batch of material brought in from a cold dock.

Closing the loop with in-line volume control

The more reliable approach is to measure what actually matters and correct for it automatically.

Coherix 3D Volume Adaptive Control (VAC®) measures bead volume in-line, as the adhesive is applied. When the measured volume starts to move away from target, VAC automatically adjusts the dispense to bring it back. No one has to notice the change or step in.

Instead of fixed settings that only hold under the conditions they were tuned for, your dispensing process responds to the material as it actually behaves. Seasonal swings, shift-to-shift changes and batch-to-batch differences no longer have to dictate bead quality. Temperature stops controlling your process, and your team spends less time chasing it.

How does your team handle seasonal material variation?

If your beads look different in January than they did in July, or your technicians re-tune dispensers every time the weather turns, it may be time to rethink how volume is controlled.

Learn more about Coherix 3D Volume Adaptive Control or contact the Coherix team to talk through your application.

October 26, 2026