Why Adhesive Bead Volume and Placement Are Critical

In automated dispensing, quality comes down to two factors: bead volume and bead placement. Even small variations can lead to leaks, weak bonds or costly rework.

As highlighted in the Dispensing.com article, traditional systems often focus on what is dispensed, not what actually lands on the part. This gap can allow defects to go undetected.

To address this challenge, manufacturers are turning to real-time 3D inspection to verify bead volume and location directly on the part, enabling immediate feedback and improved process control.

The result is more consistent quality, less scrap and greater confidence in every dispense.

Read the full article on Dispensing.com